Cars who rolls over.

Master_Findus

Hi,

I replaced some cars but they are roling over.

How can i fix it ? I don't have any id where and how i can do this in the handling.

So if someone could help me, it's would be with pleasure.

Thanks you.

a63nt-5m1th

Quickest & easiest way, without disrupting your vehicles handling too much, is to lower the 'z' parameter in this line (below) in 'handling.meta' (can be negative (-) if required).

      <vecCentreOfMassOffset x="0.000000" y="0.000000" z="lower this value" />

Usually, you only need to lower it by ~0.1>0.5 but I've had one vehicle that needed -4 or something.

If you go too low the vehicle will start doing the opposite & start tilting into the corner & raising up off the ground on the outside of the turn.